Thread Rating:
  • 4 Vote(s) - 2.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1.6 hdi turbo/conrod trouble??
#1
Hi there ive an 07 1.6 hdi that has done the bearing in in the turbo, is it possible now that it wont start that its taken in oil and bent conrods? its trys to fire up, the price of 2nd hand engines i was thinking about a full rebuild and turbo any help would be greatly appreciated, cheers
Reply
#2
If the oil from the turbo was drawn into the engine it would probably run on the engine oil. If this did happen then the motor is likely to run out of control irrespective of it being switched on or off and rev its nuts off until something lets go.
To bend the con rods you would need a lot of liquid into the bores very quickly like driving in flood water and the engine would lock solid. A little oil in the inlet side of the turbo is quite normal.
Which came first the non-start or the knackered turbo?
Why do you say the turbo is knackered, are the vanes touching the housing or is it just sloppy?
Have you checked for fault codes?
Good luck.
[-] The following 1 user says Thank You to JohnM for this post:
  • twincamtam
Reply
#3
Hello twincamtam welcome to the forum it's unlikely the engine has bent con rod's if it had oil in the bore it would of run away if it's trying to start that a good thing take the air intake into the turbo off stick a tool in or you finger's in the hole see if the vain move's if it move's up or down side to side it' gone if it has when you take it off you need to check the oil feed pipe see if it's blocked if it is it's sump off to see if the sump pick up pipe need's to be cleaned or replaced when it's done keep it well serviced
                                     Smile  It's too orangey for crow's It's just for me and my dog  Smile

                                                        Heart Heart Love a lot trust a few  Dodgy
 
                                                        

                                        
[-] The following 1 user says Thank You to Jed Clampit for this post:
  • twincamtam
Reply
#4
It is not possible and you need to change it.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Supermarket Diesel
Last Post: Top drive
Today 07:36 AM
» Replies: 3
» Views: 29
BULBS!!
Last Post: Jed Clampit
Yesterday 11:05 PM
» Replies: 17
» Views: 565
Finally a B9 Haynes Manual
Last Post: Satellitemark
Yesterday 10:43 PM
» Replies: 39
» Views: 2493
clunking noise
Last Post: Silverberlingo
Yesterday 10:35 PM
» Replies: 4
» Views: 72
TRAILER WANTED
Last Post: Silverberlingo
Yesterday 10:29 PM
» Replies: 4
» Views: 81
longitudinal roof rails
Last Post: Chrisville
Yesterday 10:27 PM
» Replies: 0
» Views: 26
Head Light Bulbs
Last Post: Hughzie
Yesterday 09:23 PM
» Replies: 36
» Views: 1140
Newbie
Last Post: Jed Clampit
Yesterday 08:37 PM
» Replies: 6
» Views: 91
first time ctroen owner
Last Post: Jed Clampit
Yesterday 08:25 PM
» Replies: 1
» Views: 45
M59 Cooling system change PDF
Last Post: coatess
Yesterday 06:46 PM
» Replies: 1
» Views: 214

[-]
Recent Visitors
Locations of visitors to this page