Thread Rating:
  • 4 Vote(s) - 4.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Alloy wheel hassle
#1
Hi,
I picked up a set of refurbished saxo oem alloys from fleabay dirt cheap. When I fitted them on my mark 2 berlingo I found the hub dosn't reach the wheel center bore
I understand you can get hub spigots but I don't know what size. I think the hub is 65.1mm but not sure about the wheel. Any help would be great. I'm not keen on wheel wobble at 70!
Reply
#2
Check it with a feeler gauge and buy spigot rings to suit. You don't say what the wheel centre bore is but any Citroen wheel should be 65.1mm. Ford use same stud spacing but the centre is smaller.
So where does this bit go then ?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Are Mud Flaps the Answer ?
Last Post: iscom
Today 01:25 PM
» Replies: 12
» Views: 338
Is anyone buying a new car AFTER April 2017?
Last Post: Opensauce
Today 12:41 PM
» Replies: 6
» Views: 118
Starting issues
Last Post: brajomobil
Today 11:56 AM
» Replies: 1
» Views: 49
2005 Berlingo
Last Post: Andre
Today 11:27 AM
» Replies: 2
» Views: 26
Tyre Change...old on front new on back
Last Post: terryd999
Today 11:03 AM
» Replies: 10
» Views: 120
Newbie
Last Post: Andre
Today 11:03 AM
» Replies: 5
» Views: 78
Insurance cost
Last Post: geoff
Today 10:33 AM
» Replies: 2
» Views: 75
Slow starter (diesel)
Last Post: geoff
Today 10:28 AM
» Replies: 12
» Views: 290
REAR AXCEL
Last Post: V6BOY
Today 09:54 AM
» Replies: 6
» Views: 158
Finally a B9 Haynes Manual
Last Post: Satellitemark
Today 09:17 AM
» Replies: 35
» Views: 2291

[-]
Recent Visitors
Locations of visitors to this page