Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
B9 Washer motor
#1
Hi all,

The washer motor on my Berlingo appears to be faulty, I've managed to get my hand into the front of the drivers side wing and get the wiring connector off of the motor and tested the 12v supply to the motor , which goes from 0 to 12v when the switch is operated so I've concluded the motor is not working.
Does anyone know how to replace the washer motor ? While I can get to the wires I don't think I could remove the motor/pump the same way.
All info most welcome.

Mark

Sent from my BUSH 5 Android using Tapatalk
Reply
#2
Best approach is to remove the wheel arch liner, so removal of the o/s/f wheel is the best way.
Once this is off, you will be able to see what is required much easier. The motor is pushed into the water bottle , there is a rubber grommet in the bottle to seal it in.
A gentle pull or tweak with a flat screwdriver should coax the old pump out, followed by a few litres of water usually, so prepare to get wet.
A smear of washing up liquid on the new pump will get it to slide into the grommet easily, then swap your pipes & wiring connector.
[-] The following 1 user says Thank You to Lighty for this post:
  • ron
Reply
#3
Hi Lighty,

Many thanks, pump is on route so hoping to fit over the weekend (if it stops raining long enough)

Mark
Reply
#4
Is it the same on the M59?
Reply
#5
Yes its behind the arch liner and easy to do.
Are we there yet????? No we fecking ain`t  gggggrrrrrrr
Ex 1.6hdi van now 3 seater 1.4 multispace
[-] The following 1 user says Thank You to Tomcat3 for this post:
  • Growler73
Reply
#6
Hi Guys,

Finally the sun shines and I have time to replace the washer pump / motor, wheel removed jacked up and most of the inner arch fittings removed, then I discover a inspection hatch in the bottom at the front of the arch liner, at this point the motor is off and I continue the job, but I'm pretty sure the inspection hatch is there to access the washer motor without removing the wheel or the arch liner !
So if anyone else is undertaking this job it might be worth checking if your arch liner has the inspection hatch !
The job was as easy as previously described and I'm thankful for the input and advice given.

Mark
[-] The following 1 user says Thank You to Satellitemark for this post:
  • patch
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
New Berlingo Auto Box - Anyone have one?
Last Post: rubberrat
Today 01:30 PM
» Replies: 3
» Views: 176
Help needed have immobiliser fault and fan probl...
Last Post: Dennyboy
Today 01:02 PM
» Replies: 0
» Views: 21
BerlingoForum.co.uk moving over to BerlingoForum...
Last Post: Andre
Today 11:23 AM
» Replies: 2
» Views: 203
Lucas mechanic fuel pump - disassembly and timin...
Last Post: yanivh
Today 11:01 AM
» Replies: 0
» Views: 29
Head Light Bulbs
Last Post: Tree
Today 08:38 AM
» Replies: 32
» Views: 903
EGR solenoid
Last Post: silver-slug
Today 08:31 AM
» Replies: 19
» Views: 1427
ABS Modul
Last Post: brajomobil
Today 08:07 AM
» Replies: 2
» Views: 114
Speedo/milometer fault
Last Post: Gixxerguyk8
Today 12:28 AM
» Replies: 15
» Views: 1460
Which wheel nuts?
Last Post: Stu999
Yesterday 11:50 PM
» Replies: 0
» Views: 57
VAN SECURITY
Last Post: ricc
Yesterday 08:29 PM
» Replies: 5
» Views: 178

[-]
Recent Visitors
Locations of visitors to this page