Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EML light and limp home
#1
Evening all,

I was hoping to get a little assistance. 

I needed to replace the battery, which I did yesterday making sure I did it correctly. Since then the EML light has been on. Now I did a BSI reset and the EML went out for a while and then came on again and the engine went into limp home mode.  I stopped and restarted the engine and it ran normally but with the EML light on. I have had a reading of P1197 (key off voltage low) from a generic reader which possibly indicates injectors from what I have read. 

Is is a 2004 2.0 HDi.

Anyone got any ideas or help, it would be greatly appreciated. 

Thanks

BM
Reply
#2
Here you have similar problem....

https://translate.google.com/translate?h...Ft%3D67306


Measure resistance of injector

" faulty has 79kom and everyone else on 200kom "

and report back....

Best regards,
brajomobil
Reply
#3
Either a faulty injector or wiring. Measure the resistance of each injector and you will probably find 1 that's out. If they are OK, check wiring injectors to ECU
Reply
#4
Thank you guys.

I think I may have found the fault. I have been lucky to borrow a generic code reader and have read the codes as they come up. Now a strange thing is that it goes into limp home move after turning right, usually with a gear change involved. I cleaned all the connections to the injectors and had a look at the loom, found a small snag on a wire, but it hadn't gone through. I taped it up to check but had to wiggle the loom. I took the car for a test to a friend and she ran beautifully until I got to the last roundabout, and limp home mode. Cleared faults and went again to the roundabout and the same again, had a wiggle of the look and lo and behold, lower down a wire is snagged and has gone green. Put tape round it and hut the plastic loom channel and off again, and so far so good. Getting it fixed properly on weds when I have a little more time.

Sorry that was long winded, but just in case you don't want to read all that the fault is more than likely a chaffed wire!

Thank you for the help and figures crossed.
[-] The following 1 user says Thank You to Bigmoose for this post:
  • brodfather11
Reply
#5
(11-04-2016, 06:43 PM)Bigmoose Wrote:  Thank you guys.

I think I may have found the fault. I have been lucky to borrow a generic code reader and have read the codes as they come up.  Now a strange thing is that it goes into limp home move after turning right, usually with a gear change involved. I cleaned all the connections to the injectors and had a look at the loom, found a small snag on a wire, but it hadn't gone through.  I taped it up to check but had to wiggle the loom. I took the car for a test to a friend and she ran beautifully until I got to the last roundabout, and limp home mode.  Cleared faults and went again to the roundabout and the same again, had a wiggle of the look and lo and behold, lower down a wire is snagged and has gone green.  Put tape round it and hut the plastic loom channel and off again, and so far so good.  Getting it fixed properly on weds when I have a little more time.

Sorry that was long winded, but just in case you don't want to read all that the fault is more than likely a chaffed wire!

Thank you for the help and figures crossed.
Glad you found it without emptying your wallet Wink
Strawberry flavoured windows  Dodgy
Reply
#6
Almost did empty the wallet Ron, but decided on logical thinking.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Fuel Guage wrong
Last Post: Solent
Today 07:36 AM
» Replies: 4
» Views: 113
REAR AXCEL
Last Post: polar
Today 06:12 AM
» Replies: 1
» Views: 30
Odd Issues with Rear Door Sensor
Last Post: GerardKeating
Today 12:27 AM
» Replies: 0
» Views: 27
Gearbox Fluid
Last Post: AlanS
Today 12:18 AM
» Replies: 14
» Views: 353
Longitudinal Roof rails on 2010 model
Last Post: Chrisville
Yesterday 08:42 PM
» Replies: 0
» Views: 42
radio code
Last Post: Tomcat3
Yesterday 07:14 PM
» Replies: 1
» Views: 48
Donation
Last Post: terryd999
Yesterday 06:15 PM
» Replies: 2
» Views: 53
Beeping with no error lights!!!
Last Post: sjparky
Yesterday 05:34 PM
» Replies: 11
» Views: 3779
Good Evening to you all.
Last Post: ron
Yesterday 04:33 PM
» Replies: 7
» Views: 214
New Berlingo Auto Box - Anyone have one?
Last Post: rubberrat
Yesterday 01:30 PM
» Replies: 3
» Views: 220

[-]
Recent Visitors
Locations of visitors to this page