Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[Engine] Oil Pressure Insuffcient
#1
Hi all,

My berlingo 2006 1.6hdi has just started showing 'oil pressure insufficient' on the display for about 3 seconds when you start the engine (stop light also shows).

The car is also clattering as well more than it should.

Would you have any idea on what could be wrong?
Should I just change the oil, filter and switch?

Thanks

Martin
Reply
#2
Did you check the oil level?
2010 Berlingo Multispace HDi 110 with FAP.  Persamos green.

Reply
#3
Yeah, oil level seems fine.
Reply
#4
what service history does it have - how many miles has it done - is it smoking or down on power - are the injectors leaking - what is the play like in the turbo bearings?
Reply
#5
It has 2 years service history (i.e. when i've had it). not smoking or down on power. done 126k. Just had 1 injector reconditioned and I think 1 more might be a little damp.
Dont know what the turbo is like.
Reply
#6
when was the last service done?
Reply
#7
how about the power and smoke?
Reply
#8
I would be inclined to remove the sump and modify the oil pick up by removing the strainer.

fill with a new filter and oil of the correct spec, go for a short drive eg 10 miles come back and renew the oil and filter.

This is the minimum - you also need to inspect the turbo like i said and i may be wise the modify the turbo oil feed pipe eg remove the filters from the banjo bolts.

It could be the oil pressure switch but i would not take any chances with a 1.6hdi
Reply
#9
last service done about 2 months ago. no loss of power and no smoke.

ok thanks for that. I'll get them to remove the sump and remove the strainer.
I can then take it home and back the next day for the same again. It shouldn't be too dirty as it was only serviced 2 months ago.

What oil would you put in it?

thanks
Reply
#10
Use this or equivalent Total Quartz Ineo ECS 5W30 Engine Oil.

That is your staring point anyway whist the garage have it in get them to do a diag on it to see if any fault codes come up also ask them to check turbo bearings.

If an injector seal is leaking you can hear them chuffing - so get that one you suspect checked.

Hope all goes ok Swarv
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Which MK is my 2018 Berlingo?
Last Post: ParkinRJ
Today 07:42 PM
» Replies: 0
» Views: 17
Berlingo multispace clocksping nightmare!
Last Post: dvee50
Today 07:34 PM
» Replies: 0
» Views: 12
Phone call in progress
Last Post: Leonberger
Today 03:56 PM
» Replies: 5
» Views: 76
HDI injectors failing
Last Post: drc
Today 06:12 AM
» Replies: 0
» Views: 38
Airbag light won't go out
Last Post: Multispacer
Today 12:00 AM
» Replies: 1
» Views: 39
Berlingo multispace Clockspring issue
Last Post: Multispacer
Yesterday 11:39 PM
» Replies: 1
» Views: 51
M49 wiper blades
Last Post: geoff
Yesterday 07:48 PM
» Replies: 4
» Views: 49
DV6C 9HL injector options
Last Post: KD305
Yesterday 06:25 PM
» Replies: 4
» Views: 175
brake master cylinder
Last Post: BigVtwin996
Yesterday 03:28 PM
» Replies: 2
» Views: 39
Hello
Last Post: OMG
Yesterday 01:11 PM
» Replies: 1
» Views: 60

[-]
Recent Visitors
Locations of visitors to this page

[-]
Hosting by

QuickHostUK