Rear quarter panel wiring

[C4LL_D]

That's a good point I did look at the fuse box in engine bay and there is two of those chunky beige/yellow cables there so just assumed it should be fused. I do have a towbar and electrics fitted but could it be they tapped into something else

[C4LL_D]

At this rate I might put scotch locks on every cable and keep testing til it works

[C4LL_D]

Pulling my hair out think I'm just going to have to run wire from existing 12v socket down by gearstick and hide cable all the way back. It's always the "little" jobs that take the most time.

[C4LL_D]

Job done! It's not a permanent live feed so keys need to be in ignition but not that fussed. Popped out one of the interior rear lights and found the live then tapped into the same numbered wire further down and did it that way. Broke all the clips when taking the panel off so need to get some more but for time being used some I had bought ages ago from halfords where you push them in and turn screw.
[Image: udu6ynuj.jpg][Image: u6ynatu3.jpg][Image: u3e8azy4.jpg]
And if they had of had a 12v in boot as standard like my previous 206sw it would of saved me the bother but I do like tinkering on.