Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help please
#1
Hi guys I have a 16 hdi and I'm fitting a new turbo tomorrow, I'm ok on this bit but I've got to change the oil pipe to the turbo, how easy is it to do ??? Thanks


It's a 57 plate

Sent from my iPad using Tapatalk
Reply
#2
The oil feed pipe is situated behind the particulate fitter and wraps around the filter housing behind the heat shield, there are two banjo bolts one on either end and the torque is 22nm for the banjo bolts, you have to remove the heatshield and particulate filter to gain access, there three bolts in the top of the outer heat shield, two either side further down, then you need to remove the outer shield

Then undo both cat clamps and the two thirteen mm copper bolts either side near the bottom, the dpf will now slide out, and the back heatshield will come out aswell

The pipe starts about halfway up the block and twists and turns around the right side of the turbo... Don't lose the copper washers if you've not got new ones, there will be two at each end... Wink

You should also remove the sump and make sure the oil pick up pipe isn't all gunked up and give the sump a clean out too aswell as change the oil and filter too
[-] The following 2 users say Thank You to dumdum for this post:
  • ron, ronnie a
Reply
#3
Thanks Ron


Sent from my iPad using Tapatalk
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Taking along time to heat up/warm the cabin
Last Post: Hora
Today 12:37 PM
» Replies: 0
» Views: 3
Slow starter (diesel)
Last Post: ricc
Today 11:53 AM
» Replies: 15
» Views: 336
Mesh Bulkhead
Last Post: Jelevents
Today 11:37 AM
» Replies: 0
» Views: 13
2005 Berlingo
Last Post: len glover
Today 10:10 AM
» Replies: 6
» Views: 94
Supermarket Diesel
Last Post: polar
Today 09:28 AM
» Replies: 4
» Views: 49
clunking noise
Last Post: ffrenchie
Today 09:26 AM
» Replies: 5
» Views: 85
BULBS!!
Last Post: Jed Clampit
Yesterday 11:05 PM
» Replies: 17
» Views: 602
Finally a B9 Haynes Manual
Last Post: Satellitemark
Yesterday 10:43 PM
» Replies: 39
» Views: 2497
TRAILER WANTED
Last Post: Silverberlingo
Yesterday 10:29 PM
» Replies: 4
» Views: 87
longitudinal roof rails
Last Post: Chrisville
Yesterday 10:27 PM
» Replies: 0
» Views: 30

[-]
Recent Visitors
Locations of visitors to this page