Thread Rating:
  • 23 Vote(s) - 3.09 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Oil Pressure Switch
#1
Hi,
Its for my dads 02 1.4 petrol Berlingo.
Noticed that his oil pressure switch only has 1 wire going into it, and looks like theres a stump on the plug where another wire used to be, or has been cut.

Is this normal? I thought would need a live and a earth.
The car was repaired by insurance after a crash, radiator and everything got done, so im wondering if it was damaged then, and not repaired?


Its just under the housing for the oil filter (paper cartrdige type)

If anyone could look at theres and tell me if theres has 1 or 2 wires, might have a heatshield wrap around it .

Thanks
Reply
#2
(22-12-2011, 12:28 AM)tommyberlingo Wrote:  Hi,
Its for my dads 02 1.4 petrol Berlingo.
Noticed that his oil pressure switch only has 1 wire going into it, and looks like theres a stump on the plug where another wire used to be, or has been cut.

Is this normal? I thought would need a live and a earth.
The car was repaired by insurance after a crash, radiator and everything got done, so im wondering if it was damaged then, and not repaired?


Its just under the housing for the oil filter (paper cartrdige type)

If anyone could look at theres and tell me if theres has 1 or 2 wires, might have a heatshield wrap around it .

Thanks

Hi, If it's the oil pressure switch it will only have one wire as it switches to earth when there is no pressure. What is the Fault you are getting ?? Confusedcratch:
2006 2.0hdi 600 with bench seat.  Cool
Reply
#3
Hi thanks for the reply.
Im not getting a fault with it, or any oil light coming on dash, i just noticed it, thanks for the reply.

There is a fault with van stalling and low rpm only when cold, i have another thread open in here.

Diagnostic showing cylinder 4 misfiring due to low fuel level. also showing vehicle speed sensor problem. But no symptoms of that being faulty apart from fuel management is off.

I took injectors out, cleaned number 4 and cylinder 4 misfire fault hasnt came back, but VSS problem still there, so have ordered part. I dont see how this would effect fuel management only when cold though.
I have replaced the ECT sensor, cleaned injector on cyl 4, replaced spark plugs, replaced air and fuel filter, cleaned throttle body out.

On diagnostic the air intake temp sensor seems fine, so I am now stumped lol.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Taking along time to heat up/warm the cabin
Last Post: Johny555
Yesterday 11:13 PM
» Replies: 6
» Views: 122
New tablet fitted
Last Post: Washeymag
Yesterday 11:11 PM
» Replies: 0
» Views: 22
1.6hdiTurbo Over Boost OBD code P0234
Last Post: berlingo16hdif
Yesterday 11:00 PM
» Replies: 11
» Views: 14441
Supermarket Diesel
Last Post: Silverberlingo
Yesterday 08:26 PM
» Replies: 6
» Views: 129
2005 Berlingo
Last Post: len glover
Yesterday 07:23 PM
» Replies: 7
» Views: 120
Next gen berlingo multispace
Last Post: wildoat
Yesterday 06:24 PM
» Replies: 10
» Views: 229
clunky gear change
Last Post: Hora
Yesterday 05:23 PM
» Replies: 1
» Views: 49
Tyre Change...old on front new on back
Last Post: ricc
Yesterday 05:15 PM
» Replies: 13
» Views: 267
Mesh Bulkhead
Last Post: Jelevents
Yesterday 03:13 PM
» Replies: 3
» Views: 80
longitudinal roof rails
Last Post: Corker
Yesterday 02:48 PM
» Replies: 1
» Views: 69

[-]
Recent Visitors
Locations of visitors to this page