02-11-2015, 07:38 PM
(This post was last modified: 02-11-2015, 07:42 PM by gazahull.)
hi. i did mine on mk3 thru the bonnet cable into passenger side no drilling............you may need to remove battery to get access.......
I have also pulled a cable like that. From the battery I went through the rubber around the cable bundle, then down to the floor, removed the metal plate on the doorsill, and threaded the cable under that, then behind the side panel beside the rear passenger seat(Remember, I have the steering wheel on the left side, and there's no rear passenger door on the driver's side) and from there back to the back of the panel on the lefthand side of the trunk.
(02-11-2015, 02:58 PM)steve4736 Wrote: I have a 1.9d Multispace 2001 which has been converted to a mini camper van and am planning to fit a split charge relay to the leisure battery which is located behind the passenger seat. My question is- where can I run the cable through from the engine compartment? I can see some bunched wires disappearing into the passenger side from the engine compartment but cannot see where they come out inside the car. So far I have removed the glove box and some of the sound proofing, but really do not want to remove the entire fascia. Does anybody have any ideas?
On my 52 reg - rip
there was a grommet in the bulkhead on the drivers side, to get at it I had to remove the trim around the windscreen and then its in the void that it covered it comes out above the BSI and fuses , not sure if that helps?
The following 1 user says Thank You to Jakejjt for this post:1 user says Thank You to Jakejjt for this post
Big thanks for the replies guys! I will have a look and see which solution works.
I have had a look and the solution described by Tomcat3 appears to be the obvious one on my vehicle. Thanks!