Thread Rating:
  • 15 Vote(s) - 2.73 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SECURITY KEYPAD PROBLEM
#1
hi there my first post and ive a problem :brickwall: is there anyway of setting the keypad to defaut ie 1111.
i once entered the wrong code a few times and had to wait 30 mins for it to reset and that worked fine,this time i stalled the van after starting up and tried to restart but after putting the code in i find the green light coming on but the red light is also on.
it wont let me change the code either as im only getting 4 beeps then the keypad doesnt respond...any help greatly appreciated...regs KEV
Reply
#2
?????
Reply
#3
Has your vehicle had an aftermarket keypad operated immobiliser fitted ?

If yes and it is faulty best remove it & go back to standard, trace wires back thru harness find out what it inhibits & connect wiring back to standard.
Or get a like for like replacement & fit.

If its declared on your insurance don`t forget to advise them of it`s removal if declared on policy !
What vehicle do you have ?
2003 Citroën Berlingo 2.0HDi Multispace Desire
Reply
#4
If it's anything like the keypad for the Xantia you can set the code. Wasn't aware of Berlingos having the keypad though.

To change the code for a Xantia you do the following Put your code in. Press C. Put new code in and press C again. It should beep and go to green. That's the only way to reset it I'm aware off. Did it a couple of times on my Xantia when one of the buttons decided it wasn't going to work as often as I wanted it to.
2010 (B9) Berlingo Multispace XTR HDi 112 - Kyanos Blue
Previously - 2002 (M49) Berlingo Multispace 2.0 HDi Diesel - Arctic Steel
Reply
#5
Our old ZX had a keypad immobiliser - I think it was standard on the 'special edition' (Elation II) we got. As the Berlingo is based on the ZX, it seems reasonable that some might have the keypad - earlier ones maybe? I think Mike has got the procedure right. There's also a procedure for setting it to a service mode, so you don't need to give the garage your code. I wonder it that's what might have happened, as I think it might put both lights on to alert you. There is also a reset procedure, but I can't remember what it is. Have a look in the resources page on this site - there's a link to a site for manuals and you might find one there. If not for the Berlingo, try the ZX/Xsara/Xantia manuals.
The Bus: 2009 MkIII VTR HDi 90, 7 Seater
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Tyre Change...old on front new on back
Last Post: malgpz900
Today 09:20 PM
» Replies: 2
» Views: 40
Finally a B9 Haynes Manual
Last Post: Satellitemark
Today 08:26 PM
» Replies: 33
» Views: 2202
Fuel rail pipe replacement
Last Post: Peter Palmer
Today 08:19 PM
» Replies: 2
» Views: 33
REAR AXCEL
Last Post: Tomcat3
Today 07:31 PM
» Replies: 5
» Views: 129
Berlingo B9 2008 Just Testing The Water
Last Post: nickyboy4
Today 06:34 PM
» Replies: 0
» Views: 26
Starting issues
Last Post: technique1966
Today 06:00 PM
» Replies: 0
» Views: 26
Insurance cost
Last Post: jonny705
Today 05:33 PM
» Replies: 0
» Views: 30
Newbie
Last Post: j.ted
Today 04:40 PM
» Replies: 2
» Views: 41
Are Mud Flaps the Answer ?
Last Post: Top drive
Today 04:02 PM
» Replies: 11
» Views: 310
Is anyone buying a new car AFTER April 2017?
Last Post: Solent
Today 03:35 PM
» Replies: 1
» Views: 51

[-]
Recent Visitors
Locations of visitors to this page