16-01-2012, 08:26 PM
Yup - wiper arms off and the scuttle (mind the wee torx screws as well). The motor is on the right hand side and you will need to prise the linkage off the actual motor end - it is a push fit ball joint connection.
Mine took a bit of a wriggle before I could get fingers in to disconnect the wiring block but apart from that no real worries.
Assuming it is the same type, there was a black plastic cover on the plastic gear compartment (where the electrical contact are also). This is held on by a couple of clips and sealant but also comes off easy enough.
Mine took a bit of a wriggle before I could get fingers in to disconnect the wiring block but apart from that no real worries.
Assuming it is the same type, there was a black plastic cover on the plastic gear compartment (where the electrical contact are also). This is held on by a couple of clips and sealant but also comes off easy enough.