Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
if not head gasket-What?
#1
Hello Everyone

I started with this back end of April. The garage could not work on the car and my daughter is away so I have used her car.
MY berlingo seemed to have blown the head gasket and a pressure test confirmed.
However the engine on starting sounds good and now the top has come off it is not apparent where the gasket has failed.
So the mechanic is looking for other possible causes of the car boils very quickly and pressure test indicates head gasket.
He said a cracked block could cause the symptoms.
There is some sign, but not a lot, of emulsion in the water and under the engine cap. The oil dip stick has no emulsion nearly full oil. The car has been using about half pint of water in 6 weeks. The machanic said the emulsion was not really significant in a car dated Feb 1st 2001.

The car has a history of the heater matrix failing and the replacement failing in a couple of weeks and then a few months later the thermostat failed.

Any ideas would be really appreciated.
I really like the car and would like it working again.

Thanks
Reply
#2
What were the reasons behind you thinking the head gasket had failed?

Has your coolant level been dropping and your oil level rising?

What do you use to top up your coolant?
Reply
#3
Have you check the rad it self i think they are prone to blocking up after time on the mk1
Sorry going through my head file's their not as good as they use to be i mite be wrong it could be the vx corsa
but still check anyway
                                     Smile  It's too orangey for crow's It's just for me and my dog  Smile

                                                        Heart Heart Love a lot trust a few  Dodgy
 
                                                        

                                        
Reply
#4
A Pressure test does NOT prove that the gasket is shot.
It just shows that there's SOMETHING wrong with the cylinders.

You could have worn rings on the pistons, the valves may not be closing properly...

Car boiling quickly can be caused by a lot of things.

The 1.4i for example is notoriously difficult to properly bleed air from.

Which engine model do you have?
Do you have AC or not?
Reply
#5
Check that the two? small bore pipes from the cylinder head to the expansion tank are not blocked. A blockage can cause similar symptoms as a blown head gasket.
Reply
#6
Is it blowing very white smoke or very black smoke, my head G went and water burns white while oil burns black, you could also have a warped head due to over heating which will need replacing if this turns out to be the issue.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
600lx or 800lx
Last Post: terryd999
Today 05:16 PM
» Replies: 0
» Views: 5
Fuel rail pipe replacement
Last Post: Peter Palmer
Today 04:50 PM
» Replies: 3
» Views: 71
hi all
Last Post: Andre
Today 04:07 PM
» Replies: 1
» Views: 19
New Berlingo Auto Box - Anyone have one?
Last Post: CourierJim
Today 03:47 PM
» Replies: 7
» Views: 312
Tyre Change...old on front new on back
Last Post: CourierJim
Today 03:37 PM
» Replies: 11
» Views: 157
Is anyone buying a new car AFTER April 2017?
Last Post: CourierJim
Today 03:30 PM
» Replies: 7
» Views: 139
Slow starter (diesel)
Last Post: zedhead
Today 03:22 PM
» Replies: 13
» Views: 302
Are Mud Flaps the Answer ?
Last Post: berreke
Today 02:13 PM
» Replies: 13
» Views: 365
Insurance cost
Last Post: jonny705
Today 02:12 PM
» Replies: 3
» Views: 87
Starting issues
Last Post: brajomobil
Today 11:56 AM
» Replies: 1
» Views: 55

[-]
Recent Visitors
Locations of visitors to this page