23-12-2012, 05:43 PM
23-12-2012, 08:53 PM
Ive had a look through my haynes manual and that was about as much use as a chocolate teapot about rev counters. Lets hope rustscrat comes along to point you in the right direction.
23-12-2012, 09:30 PM
Thanks for the reply anyway as I was considering buying a Haynes to help me out with it but guess I will wait for my next fault before shelling out on one.
25-12-2012, 09:03 AM
Hi, This is for the 1.9D XUD9 engine, non Bsi.
Item 1400 is the sensor for the tacho, described as a "Top dead centre sensor".
You should be able to check this with an ohm meter of some kind.
Two of the 3 pins should read approx 200 ohms if I can remember.
Think there is another post with a link to a you tube vid. about this.
alut:
[Image: juibkp.png]
Item 1400 is the sensor for the tacho, described as a "Top dead centre sensor".
You should be able to check this with an ohm meter of some kind.
Two of the 3 pins should read approx 200 ohms if I can remember.
Think there is another post with a link to a you tube vid. about this.
alut:
[Image: juibkp.png]
25-12-2012, 09:14 AM
Thanks very much! I will check it out.
Merry Christmas!
Merry Christmas!