Belingo 1.4 limp mode and eml - Printable Version +- Berlingo Forum (https://www.berlingoforum.com) +-- Forum: Specific Model Chat, Problems and Faults (https://www.berlingoforum.com/forum-8.html) +--- Forum: M59 Berlingo (https://www.berlingoforum.com/forum-28.html) +--- Thread: Belingo 1.4 limp mode and eml (/thread-7848.html) |
Belingo 1.4 limp mode and eml - Tworivers - 23-09-2013 Got in the car this morning, it started but ran a bit lumpy like it was cold. Drove about half a mile when I heard a beep and the eml came on. Normally I would have stopped but I had a hospital appointment that I couldn't miss. For the next 10 miles or so the car just ran in limp mode, ok on the flat but a mare on the hills. I stopped at some traffic lights when the temp seemed to start rising, as I set of the emg went out and the engine operated as normal. Drove the car home no problems either. I have had a quick look through this forum but can't find anything. I have had a similar problem before with a diesel, that turned out to be the maf sensor. Do petrol cars have maf sensors? Any other ideas? Cheers RE: Belingo 1.4 limp mode and eml - addo - 23-09-2013 I'd have the cat looked at; this might be a blocked converter. RE: Belingo 1.4 limp mode and eml - tucker - 24-09-2013 The EML coming on will have triggered a code. You will need to read it if you want a good idea without ending up with a very long list of things to check / replace. RE: Belingo 1.4 limp mode and eml - Tworivers - 24-09-2013 When you say have a look at the cat do you mean take it apart? The car as been fine today. [/align] |