21-02-2012, 07:55 AM
Hello all
Van was stuck tight in reverse today and had the clutch done about three weeks ago. On closer inspection i noticed that the swivel ball on the selector shaft had slipped from its place and i had to remove two link arms to put it back in.
All gears are fine but the gear stick when in reverse goes too far back in the van and its close to happening again, Is there something that can stop the gear stick going so far back in reverse?
Van was stuck tight in reverse today and had the clutch done about three weeks ago. On closer inspection i noticed that the swivel ball on the selector shaft had slipped from its place and i had to remove two link arms to put it back in.
All gears are fine but the gear stick when in reverse goes too far back in the van and its close to happening again, Is there something that can stop the gear stick going so far back in reverse?