The illumination on my Multi-function Display Unit went dull so this is how i replaced the bulbs which by the end the results are clear to how much more lit up the Display Unit is by the end of this process
This took me 5 to 10 minutes
At the end of changing the bulbs you will need to set the clock and date
Tools needed:
Torx T20 to remove the Display Unit
Your fingers to carefully prise off the multi-function display surround from the facia (Unless you know another way)
Step 1:
carefully prise off the multi-function display surround from the facia
[Image: IMG_1327.jpg]
[Image: IMG_1328.jpg]
Step 2:
Undo the two Torx screws
[Image: IMG_1330-1.jpg]
Step 3:
Undo the plug on the back
[Image: IMG_1331.jpg]
Push the button on the top to release the lock arm
[Image: IMG_1332.jpg]
[Image: IMG_1333.jpg]
[Image: IMG_1334.jpg]
Step 4:
Remove the plug
[Image: IMG_1335.jpg]
Step 5:
These are the three bulbs on the back on the display unit
[Image: IMG_1336.jpg]
Turn the bulbs anti-clockwise to release
[Image: IMG_1337.jpg]
This took me 5 to 10 minutes
At the end of changing the bulbs you will need to set the clock and date
Tools needed:
Torx T20 to remove the Display Unit
Your fingers to carefully prise off the multi-function display surround from the facia (Unless you know another way)
Step 1:
carefully prise off the multi-function display surround from the facia
[Image: IMG_1327.jpg]
[Image: IMG_1328.jpg]
Step 2:
Undo the two Torx screws
[Image: IMG_1330-1.jpg]
Step 3:
Undo the plug on the back
[Image: IMG_1331.jpg]
Push the button on the top to release the lock arm
[Image: IMG_1332.jpg]
[Image: IMG_1333.jpg]
[Image: IMG_1334.jpg]
Step 4:
Remove the plug
[Image: IMG_1335.jpg]
Step 5:
These are the three bulbs on the back on the display unit
[Image: IMG_1336.jpg]
Turn the bulbs anti-clockwise to release
[Image: IMG_1337.jpg]