Hi guys,
1.6HDi 2016.
Trying to enable the cruise control using Diagbox V9.68.
The cruise control should be configured at BSI & at ECU.
At BSI I set it up without a problem, changed from "absent" to "cruise control".
But at ECU it is not possible to change anything without an on line connection to PSA server. There is a message "No server connection".
Anyone have an idea, other than contact the dealer?
Thanks.
Go to dealer,fastest way to solve such problem.
(01-09-2021, 08:30 AM)Buki Wrote: [ -> ]Hi guys,
1.6HDi 2016.
Trying to enable the cruise control using Diagbox V9.68.
The cruise control should be configured at BSI & at ECU.
At BSI I set it up without a problem, changed from "absent" to "cruise control".
But at ECU it is not possible to change anything without an on line connection to PSA server. There is a message "No server connection".
Anyone have an idea, other than contact the dealer?
Thanks.
Maybe there is a local independent specialist garage you can try?
I think your diabox version is too new. After a certain version you had to connect to the makers site . You can use a earlier version 7.2 (?) which will allow you to do what you want without going to a dealer or connecting to the makers site .
Zion explained the pitfalls you can encounter with a later version.
Try this link and it'll maybe help you.
https://www.berlingoforum.com/thread-21009.html
(10-09-2021, 08:30 AM)brodfather11 Wrote: [ -> ]I think your diabox version is too new. After a certain version you had to connect to the makers site . You can use a earlier version 7.2 (?) which will allow you to do what you want without going to a dealer or connecting to the makers site .
Zion explained the pitfalls you can encounter with a later version.
Try this link and it'll maybe help you.
https://www.berlingoforum.com/thread-21009.html
Good point, I'd assumed it was the ECU that was too recent. It would be good to know where the cutoff point is for DIY / Online only changes on vehicles.
I did activate it last year with my Lexia soft 7.57