Posts: 1,642
Threads: 40
Thanks Received: 387 in 344 posts
Thanks Given: 127
Joined: Jan 2012
Location: Galloway
Reputation:
27
25-09-2018, 08:32 AM
(This post was last modified: 25-09-2018, 08:33 AM by brodfather11.)
That is if it has gaskets , some don't and rely on a bead of silicon to act as a gasket. If there is a groove round the cover then its a gasket you need , if not a tube of silicon has to do as a gasket has nowhere to sit in and will squeeze out when pressure and heat is applied. Some sumps are the same set up .
You don't know until you take off the cover.
2020 Rifter 1.5 allure
2010 B9 red XTR w a v.
2001 1.9d DW8B white Berlingo
2005 2.l green Berlingo
2001 1.9d DW8B white Berlingo
berlingo 1.4 red multispace
1993 xud 1.9 red partner
Posts: 2,677
Threads: 60
Thanks Received: 696 in 594 posts
Thanks Given: 184
Joined: Aug 2012
Location: Wales
Reputation:
44
Some years ago on a 55 plate 1.9d I needed new gaskets and found the top one was available from a motor factors and the bottom one was only available at main dealer as part of a full engine seal and gasket kit for well over a £ton.
I bought the top one and used "mastic " sealant for the bottom without issue.
As post above you need to look and see / ask at dealer with reg no to see what is needed.
With mastic it is best to read the manufacturers instructions and also seek advice if not familiar with its use for to just apply the stuff and wind down the fixing bolts untill they go tight generally doesn't work that well.
2007 M59 1.6 HDi
Serieal Berlingo owner
The following 1 user says Thank You to geoff for this post:1 user says Thank You to geoff for this post
• Art b