Anyone fitting reversing sensors or got them like me (without disable switch I hasten to add) may like this. On your computer search engine
type in 9452.95 or 9690.07. Good pictorials / photos of how to measure and fit sensors, electrical harness tie in points. Bit like the old Haynes manual photo's, rear lining panels removed, bumper off etc. Most Berlingo's are listed and shown as well as a few other Citroens and Pugs. I found it really helpful when tracing my system,
hope you do too.

Wow, way cool. Many thanks

Thanx. Good link.

Hi, Does anyone have the link above available to show how to fit reversing sensors, the link doesn't seem to work for me.

If it's to the pdf try this link

This seems to be referring to a PDF document online that has in fact been split into two parts/links. The part of the document that refers to instructions for Berlingos (mark 2 and mark 3) is in the second part - here is the link: http://www.citroen-auch.com/fiches/945295_T2.pdf

I have a y reg 2000 Berlingo. The key fobs need to be reprogrammed. A how to guide would be great. My main issue is where is the location of the transponder at the front of the car to hold key near to to programming the key. Any help would be great.

(25-08-2016, 09:00 PM)Ollie Harris Wrote:  I have a y reg 2000 Berlingo. The key fobs need to be reprogrammed. A how to guide would be great. My main issue is where is the location of the transponder at the front of the car to hold key near to to programming the key. Any help would be great. Where to place new posts would be good too. Such a newbie.

Hi
Great link
Does anybody know if my 2011 berlingo will have the loom for reverse sensors built in before I start pulling it apart on a discovery mission.

Thanks

(25-09-2016, 06:16 PM)Carl Davis Hulin Wrote:  Hi
Great link
Does anybody know if my 2011 berlingo will have the loom for reverse sensors built in before I start pulling it apart on a discovery mission.

Thanks

Carl what year and spec is your car? the video i put on youtube showing how to pop open the boot panel may be useful. quick way of checking if you have that loom in place.