![]() |
|
reversing sensors beep when braking - Printable Version +- Berlingo Forum (https://www.berlingoforum.com) +-- Forum: Berlingo Chat (https://www.berlingoforum.com/forum-6.html) +--- Forum: Tuning and Styling (https://www.berlingoforum.com/forum-17.html) +--- Thread: reversing sensors beep when braking (/thread-25614.html) |
reversing sensors beep when braking - dr268 - 04-09-2023 b9 tepee when i got the tepee the reversing sensors worked fine then they started to cheep when i touched the brakes or indicator I assumed a poor earth so reearthed them to the chassis and all was well for 6 months the cheep is now back and very annoying so i have disconnected them to stop it The power comes from a scotch lock on the reverse wire to the rear of the near side cluster Only thing that I can think is that this connection isn't good enough but since this thing is French I am wary of cutting the reverse light wire to get a good connection. Am I wise to avoid cutting it or is it ok ? thanks RE: reversing sensors beep when braking - ItsGreen - 04-09-2023 Try taking your reversing light bulbs out and see if it still does it, I think it's more likely a poor earth for the lights causing the issue, rather than anything you've done. A work around might be to put an LED bulb in the reversing lights to stop the current from the brake lights running back up through the reversing light circuit to find an earth. RE: reversing sensors beep when braking - dr268 - 04-09-2023 (04-09-2023, 04:53 PM)ItsGreen Wrote: Try taking your reversing light bulbs out and see if it still does it, I think it's more likely a poor earth for the lights causing the issue, rather than anything you've done. sounds like good advice, I do that and will probably add an additional earth to the lighting cluster if needed RE: reversing sensors beep when braking - dr268 - 05-09-2023 (04-09-2023, 04:53 PM)ItsGreen Wrote: Try taking your reversing light bulbs out and see if it still does it, I think it's more likely a poor earth for the lights causing the issue, rather than anything you've done. found a bit of corrosion on the lighting cluster pin, i cleaned it up but still got a bit of resistance so soldered an earth wire on to the cluster beep is gone i am very happy thanks |