Berlingo Forum - Search Results

7,978

09-08-2016, 09:52 PM

Thread: will not start after installing car radio
Post: RE: will not start after installing car radio

Open your drivers window, make sure everything is off, and get out and close the door. Wait for 3 mins and disconnect the battery. Wait for another three minutes and then reconnect. Wait for 30 secon...

7,978

09-08-2016, 09:52 PM

Thread: Cruise control Help, advice and pictures wanted
Post: RE: Cruise control Help, advice and pictures wante...

First check in lexia to see if the BSI recognises clutch input - Diagnosis-global-bsi-acuator test. If it does, try turning the cruse control off in both ecu and bsi, and then activating again, I thin...

8,529

03-08-2016, 11:26 AM

Thread: 2.0 HDI Head Gasket swap - Engine in situ
Post: RE: 2.0 HDI Head Gasket swap - Engine in situ

No, I left em because they were changed in the last 15000 miles, but im thinking I might just throw a new set on to be safe. The belt seems to be creeping of until it hits the cover, I don't think it'...

6,334

02-08-2016, 08:08 AM

Thread: 2.0 HDI Head Gasket swap - Engine in situ
Post: RE: 2.0 HDI Head Gasket swap - Engine in situ

Just got a small problem. I checked the timing belt today and it has been rubbing on the top cover. When I pushed the belt back onto the cam properly and hand cranked the engine it starts to wonder of...

6,334

01-08-2016, 06:56 PM

Thread: Van wont start now
Post: RE: Van wont start now

How far up the west coast are you?

13,595

28-07-2016, 12:31 PM

Thread: Van wont start now
Post: RE: Van wont start now

Bba will check just the unit, to get it read with a Lexia you need the whole car. Eco mod is set by a timer, I think to 30 mins- so if you have something on for that long it shuts everything down unti...

13,595

27-07-2016, 09:07 PM

Thread: 2.0 HDI Head Gasket swap - Engine in situ
Post: RE: 2.0 HDI Head Gasket swap - Engine in situ

Quick update- have gone 600 miles since doing open heart surgery on the bling'o, 400 towing a full trailer, and I've had a marked increase in power and a good decrease in fuel consumption. Probably bo...

6,334

27-07-2016, 09:01 PM

Thread: Berlingo wheel nut sizes?
Post: RE: Berlingo wheel nut sizes?

Wheel nuts that hold the wheel trims? Mine has aesthetic nuts on the trims but they're just part of the trim. You dont need to undo them. I think the studs are 19 mm.

4,404

26-07-2016, 09:51 PM

Thread: Van wont start now
Post: RE: Van wont start now

Get the BSI read with a Lexia, if it needs repairs I used bba reman and it's been good since. Did it ever get wet? The drain under the black panel with the windscreen wipers through it is prone to blo...

13,595

26-07-2016, 06:10 PM

Thread: Van wont start now
Post: RE: Van wont start now

If you have your drivers window open, wait 30 seconds after connecting the battery, turn on your sidelights, then turn the key. If your window is not open you will have to get somebody to sit in the c...

13,595

25-07-2016, 09:15 PM

Thread: Van wont start now
Post: RE: Van wont start now

If the battery holds charge it will, but you have to be careful disconnecting it. Wind drivers window down, turn off everything in the car, get out, wait 3 minutes and then disconnect.

13,595

25-07-2016, 12:00 AM

Thread: 1.6Hdi rough idle on startup
Post: RE: 1.6Hdi rough idle on startup

I suspect a leaky injector. If one is dripping slightly it will pool in a piston, cause it to misfire, and then burn off cold with a puff of smoke.

12,475

24-07-2016, 09:17 PM

Thread: Van wont start now
Post: RE: Van wont start now

It sounds like a duff battery or alternator to me, otherwise I would see if you can get it read by someone with a Lexia to see if the BSI has corrupted.

13,595

24-07-2016, 09:08 PM

Thread: 2.0 HDI Head Gasket swap - Engine in situ
Post: 2.0 HDI Head Gasket swap - Engine in situ

For a month or so I have been having a problem with the car losing coolant. The cooling system was becoming pressurised on runs and blowing the coolant out of the expansion tank. After prodding around...

6,334

23-07-2016, 06:39 PM

Thread: 2005 Berlingo 2.0 HDI Wet Bsi saga - ECU Flashing
Post: RE: 2005 Berlingo 2.0 HDI Wet Bsi saga - ECU Flash...

I'm going to try virginizing and recoding with the code that's in the BSI to begin with, but failing that it'll have to be a case of removing the immobiliser from the ecu. I have hit my first bump tho...

3,256

09-02-2016, 02:19 PM

Thread: 2005 2.0 HDI BSI playing up.
Post: RE: 2005 2.0 HDI BSI playing up.

Well it turns out citroen supplied me with the wrong code, which is why the key wouldn't program. New transponder allowed me to program the key, but obviously now my ecu won't unlock because the immob...

16,937

06-02-2016, 12:12 PM

Thread: 2005 2.0 HDI BSI playing up.
Post: RE: 2005 2.0 HDI BSI playing up.

I had a trip to the scrappy today and picked up a couple of rings and a comm 2000 unit, all produce exactly the same results. Im going to try separating the blade from the fob, taping the fob to the t...

16,937

03-02-2016, 08:42 PM

Thread: 2005 2.0 HDI BSI playing up.
Post: RE: 2005 2.0 HDI BSI playing up.

Followed that guide to the letter, still no luck programming keys. I have noticed in pp2000 the key presence switches between present and not, I can get it to stabilise "present" by removing the trans...

16,937

03-02-2016, 06:00 PM

Thread: 2005 2.0 HDI BSI playing up.
Post: RE: 2005 2.0 HDI BSI playing up.

Can you check that link for me? It's sending me to a post about a tent sale.