04-06-2020, 11:22 AM
Hi all,
B9 Peugeot Partner Teepee, 2010, petrol.
Driving fine, no issues, not left for any real length of time recently.
Was driving last night, pulled into a petrol station (didn't fill up). Stopped, turned off engine. I think at this point I may have inadvertently done some combination of steps that resulted in something in the car/key being reset or altered (possibly holding brake pedal and ignition on for some period, or something similar).
The car will now not start. When key is in ignition, generally "Economy Mode, Active" shows on the display, various lights flash on the dash, and there is a clicking from glove box area. Cannot hear starter motor turning.
Remote locking does not work. Windows won't go down.
Spare key makes no difference.
I have disconnected the battery a few times, made no difference.
I have done what I believe to be the BSI reset process (http://www.bba-reman.com/gb/content/peug...ot_process), didn't seem to make any difference.
Does anyone have any ideas on what might have happened, and what I can do? Are there steps I can take to rule out various problems?
Many thanks,
Duane.
B9 Peugeot Partner Teepee, 2010, petrol.
Driving fine, no issues, not left for any real length of time recently.
Was driving last night, pulled into a petrol station (didn't fill up). Stopped, turned off engine. I think at this point I may have inadvertently done some combination of steps that resulted in something in the car/key being reset or altered (possibly holding brake pedal and ignition on for some period, or something similar).
The car will now not start. When key is in ignition, generally "Economy Mode, Active" shows on the display, various lights flash on the dash, and there is a clicking from glove box area. Cannot hear starter motor turning.
Remote locking does not work. Windows won't go down.
Spare key makes no difference.
I have disconnected the battery a few times, made no difference.
I have done what I believe to be the BSI reset process (http://www.bba-reman.com/gb/content/peug...ot_process), didn't seem to make any difference.
Does anyone have any ideas on what might have happened, and what I can do? Are there steps I can take to rule out various problems?
Many thanks,
Duane.