30-03-2021, 04:03 PM
Hi all, has anyone found an ingenious way of neatly storing an MTB in the back of the B9?
Got a bike on the way and a very full shed so it will probably spend a lot of time in the van! Only issue is I've got an ageing pooch who goes in the back of the van daily, so there's already a plastic ramp in there and a small dog bed. I think the ramp is going to end up attached to one of the walls at some point, but until the bike arrives I can't really visualise how bits are going in.
Ideally I don't want to put a fork mount directly into the floor as it'll get in the way if I shift anything large in the van. Sides of the van are plied with wheel arch boxes, so I could trim a bit off the bottom of these and slide stripwood underneath them and across the back with a fork mount in it and slide it back out if I need the fork mount out the way.
Anyone got any smart fixes already?
Cheers,
Sparx
Got a bike on the way and a very full shed so it will probably spend a lot of time in the van! Only issue is I've got an ageing pooch who goes in the back of the van daily, so there's already a plastic ramp in there and a small dog bed. I think the ramp is going to end up attached to one of the walls at some point, but until the bike arrives I can't really visualise how bits are going in.
Ideally I don't want to put a fork mount directly into the floor as it'll get in the way if I shift anything large in the van. Sides of the van are plied with wheel arch boxes, so I could trim a bit off the bottom of these and slide stripwood underneath them and across the back with a fork mount in it and slide it back out if I need the fork mount out the way.
Anyone got any smart fixes already?
Cheers,
Sparx
![[-]](http://berlingoforum.b-cdn.net/images/collapse.png)
