Heater control unit bulb replacement ?

[PowerUser]

Hi to all,

I cannot find in whole google how to replace those bulbs for light on the heater and ventilation part. Can someone please tell me what is the way for doing that ? One mechanic told me that I should just pull the 3 dials out but I dont think so, it does not move and I dont want to break something.

Thanks a lot

[Tomcat3]

Have a read of this thread to give you an idea http://www.berlingoforum.co.uk/thread-77...ight=bulbs
There is a thread on here with full pictures somewhere if you do a search.

[PowerUser]

Tried to search but havent found it. Pictures would be really helpful.

[WOLVES FC]

The way I done it was to Pull out storage compartment above heater control panel. Pull off the grey trim from below the heater panel. Remove visible screws holding panel in place. This is the awkward bit,pull panel out as far as pos and push it back in the hole it came from (cables still connected) with back of the panel uppermost.locate blown bulb and find a small socket that will fit. Put socket wrench on socket and give it 1/4 to 1/2 turn, pliers might be needed to extract bulb. Replacement is the above in reverse.good luck.


Sent from my iPad using Tapatalk