[WTB] drivers seat

[alsation10]

wanted mk1 berlingo multispace (51)drivers seat not bothered of colour as long as the seat is in good condition. as close to essex as possible please.
thanks mick

[Tomcat3]

There is this one being broken in Norfolk http://www.ebay.co.uk/itm/Citroen-Berlin...SwNgxWEnhB
This one is closer in Colchester http://www.ebay.co.uk/itm/citroen-berlin...SwwbdWPHRk

[alsation10]

There is this one being broken in Norfolk http://www.ebay.co.uk/itm/Citroen-Berlin...SwNgxWEnhB
This one is closer in Colchester http://www.ebay.co.uk/itm/citroen-berlin...SwwbdWPHRk

thanks. the 1 in colchester he`s already sold it.shame as they`re the same colour as mine.lol

[alsation10]

out of curiosity,would a seat from a 53-56 model fit?
thanks in advance

[geoff]

out of curiosity,would a seat from a 53-56 model fit?
thanks in advance

Most likely so ..... mine is '55 and the rear seat mounts are bolted vertically, front seat mounts are bolted horisontally with bolt facing the rear.  I changed my seats as they were a poor design in my opinion and went for Rover seats which needed bespoke brackets which fortunately I was able to make however I am reliably told ( Ron ) that the later seats perhaps 2007 / 08 are much better again than 53-56 models, hope this helps.

[alsation10]

out of curiosity,would a seat from a 53-56 model fit?
thanks in advance

Most likely so ..... mine is '55 and the rear seat mounts are bolted vertically, front seat mounts are bolted horisontally with bolt facing the rear.  I changed my seats as they were a poor design in my opinion and went for Rover seats which needed bespoke brackets which fortunately I was able to make however I am reliably told ( Ron ) that the later seats perhaps 2007 / 08 are much better again than 53-56 models, hope this helps.

i can get hold of a seat from a 54-58 mk2 model.is it possible to change over the runners? as the mounting is different

[geoff]

Cannot help with swopping seat runners sorry ..... I've seen runner spot welds ground off to remove them and then weld back on a fit different - I think on here somewhere when different seats were fitted.