YACCRT (Yet another cruise control retrofit thread)

[Collapsedsuspension]

2007 Berlingo 1.6 16v petrol - I have installed the non-limiting cruise stalk and have tried to activate it in Lexia.

I can find reference to cruise in the ECU and BSI config menus. Not in the instrument panel config like the B9. In the BSI I get the choices for the cruise option are missing/cruise/cruise+limiter I chose cruise.
In the ECU I get three separate choices - cruise (Y/N), cruise with limiter (Y/N) and finally cruise no limiter. That last one, the one I want, only has the 'disabled' (or equivalent word) choice available. Is this the same way cruise is disabled in the 1.6HDi? I was sure I read somewhere someone got cruise on the 1.6 petrol.

I understand the ECU has got to go into the sleep mode to finalise the setting but the hour and a half I left it should do, right?

It's a seimens BSI and Bosch ME754(something like that) ECU.

Any answers or hints greatly appreciated, TIA.

[cancunia]

Look for Brajomobil's posts on this subject.

[Collapsedsuspension]

So I've tried setting everything back to stock then changing the settings again in a different order (ECU > BSI), but this hasn't helped. I still get no option to enable cruise without limiter in the ECU. I have a clutch switch and the brake switch has four wires - I think this is correct for cruise.

I've just noticed that the horn doesn't work with the key in - I'll try the fix on that issue and see if it makes a difference. Lexia reports a fault in the 'steering column switch' area that might be the problem.

[Collapsedsuspension]

Does anyone have an input on the issue of the ECU not allowing 'Cruise without Limiter' option? It does allow 'Cruise with limiter'.

[brajomobil]

There is great chance that your ECU or BSI software version can't accept CC like every 1.6HDi , similar year

To confirm that you must contact your dealer. 

Options are there to set them up in Lexia but when you do them CC still not working.

Best regards,
brajomobil