Electric window help

[Lucas87]

hey up guys I’ve got a spare m49 berlingo with electric windows and central locking which I was hoping to swap over to my daily m49 I’ve got wiring behind the switch blanking plates but no wiring for the ecm on the side of the heater housing I’ve had a look and can’t see the plug tucked up along the loom. Am I right in thinking with out the ecm wiring the windows won’t work I’d swapped over to my daily and help would be fantastic thanks

[Tomcat3]

Not sure if this is right but isn't the control module for the windows behind the trim in the footwell drivers side. perhaps there is a plug there. If you have a manual im sure there is a picture of it there.

[Lucas87]

Not sure if this is right but isn't the control module for the windows behind the trim in the footwell drivers side. perhaps there is a plug there. If you have a manual im sure there is a picture of it there.

Hey mate yes it is it there on the one with the elecy windows but mine has manual and the plug isn’t there at all so guessing it’s not in the loom as I’ve had a look where the wiring goes and can’t see it any wear

[Gadgetman]

Which year models are these two?
I believe there were changes done in 2000.

[Lucas87]

Which year models are these two?  
I believe there were changes done in 2000.

Hey mate the one with out elecy windows is a 2000 and the one with is a 2002 I’ve looked up behind the dash and taken various bits of dash from etc out and can’t see the plug for the ecm on my current so I’m guessing it’s not on my loom I’m not fussed about my windows being manual was just gunna swap them while I had the spare car available for bits