Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dip beam level adjustment motor
#1
Recently noticed that when my '04 Berlingo headlights are on dip , with level adjuster switch set to 0 , the adjuster motor constantly runs ( only noticeable with engine off ).
Only way to stop it is to move the adjuster switch to position 1 ( problem then is dip beam is lower ) .
Any suggestions ?
Reply
#2
Check if something is stopping the light from reaching it's resting position and activating a limit ?
So where does this bit go then ?
Reply
#3
I have had this on two of the three 'lingos I have and it was cured by replacing the level switch. Easy to get hold of but I don't know how much a new one might be.
Black Hyundai i30 1.6CRDI 2011
Silver 1.9D Mutispace desire 2004 DW8B non Turbo..
White 1.9D Van 2005 DW8B non turbo..
Silver MGF 1.8 16v 1999
[-] The following 1 user says Thank You to ajcommercial for this post:
  • Blackshuck
Reply
#4
(20-08-2018, 10:26 PM)ajcommercial Wrote:  I have had this on two of the three 'lingos I have and it was cured by replacing the level switch. Easy to get hold of but I don't know how much a new one might be.

Thanks for that - how do you get the level switch out ?
Reply
#5
(21-08-2018, 05:55 AM)Blackshuck Wrote:  
(20-08-2018, 10:26 PM)ajcommercial Wrote:  I have had this on two of the three 'lingos I have and it was cured by replacing the level switch. Easy to get hold of but I don't know how much a new one might be.

Thanks for that - how do you get the level switch out ?

Hiya, sorry for the late response..

  The rotary switch just pops out, if you can get your hand up behind it, it is easier to get out, small bladed screwdriver from the front will do it though.. simple job once you've done it.. Good luck.
Black Hyundai i30 1.6CRDI 2011
Silver 1.9D Mutispace desire 2004 DW8B non Turbo..
White 1.9D Van 2005 DW8B non turbo..
Silver MGF 1.8 16v 1999
[-] The following 1 user says Thank You to ajcommercial for this post:
  • Blackshuck
Reply
#6
Managed to prise the switch out , but the wiring stops it short , so l can't reach the plug to disconnect it - any suggestions ?
How can I remove the dash section it is fitted to , so I can access the wiring to the switch ?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Service interval notice
Last Post: jocas74
Today 02:23 AM
» Replies: 7
» Views: 361
Winter Tyres
Last Post: geoff
Today 12:19 AM
» Replies: 0
» Views: 26
23 plate Citreon Berlingo classed as a van
Last Post: W Petsa
Yesterday 10:39 PM
» Replies: 2
» Views: 37
The creation of my personal solo-travellor.
Last Post: EM58
Yesterday 06:17 PM
» Replies: 12
» Views: 740
M59 Throttle pedal
Last Post: evdama
Yesterday 01:10 PM
» Replies: 5
» Views: 178
Berlingo 2007 1.6 hdi - intermittent sticky acce...
Last Post: Romahomepete
Yesterday 01:05 PM
» Replies: 7
» Views: 329
roof rack with slats
Last Post: BigVtwin996
Yesterday 11:53 AM
» Replies: 4
» Views: 192
Battery upgrade
Last Post: evdama
27-03-2024 03:58 PM
» Replies: 0
» Views: 99
Wanted: 2003 M59 steering rack
Last Post: evdama
27-03-2024 12:45 PM
» Replies: 1
» Views: 57
Airbag Fault Code
Last Post: Cumbrian
26-03-2024 03:06 PM
» Replies: 1
» Views: 215

[-]
Recent Visitors
Locations of visitors to this page

[-]
Hosting by

QuickHostUK