Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wipers very slow
#1
Hi, my wipers are quite slow, even on full speed. is this normal for a 2001 berlingo? 

ive seen the post about speed sensitive wipers, but not sure if any sarcasm is involved? Confused

are the linkages prone to seizing? are the motors prone to seizing/slowing down?

seems too slow to have been like this from new.

thanks.

Rob
Reply
#2
im going to strip linkages down at the weekend and grease all connections to see if it helps.

may need to replace or upgrade motor if not.

Sad
Reply
#3
I've a 2001 berlingo but the wiper speeds are OK , yours has maybe had a harder life than mine regarding rainy weather
There is not much you can do to the linkages except spray with wd40 stuff. It could be the motor on its last legs ( 18/19 years old ?) a scrappy would be a cheap replacement if needed , that's where I got some linkages after they came apart at the joints
the wiper spindles on mine were tight in their housing so maybe worth checking on yours
2001 1.9d DW8B  Berlingo
[-] The following 2 users say Thank You to brodfather11 for this post:
  • ron, rublehousen
Reply
#4
Hi,
It's often the spindles that the wiper arms fix to that are corroded in the sleeves.

If you can get to the crank part of the rack that connects to the motor take that off from the motor and move the rack by hand, if it's stiff it will probably be the spindles.

The spindles come out of the sleeves, there's normally a cir- clip holding them, clean the spindles and the sleeves and lubricate with silicone grease, you can also add a dab of grease to the balls & sockets on the linkage.

If the rack is nice and free with no stiffness maybe the motor is starting to seize, maybe a worn out bearing or bush.


.
My vehicle .... 2006 (m59) Berlingo Multispace Desire - 1.6 HDI 92 
[-] The following 2 users say Thank You to jj9 for this post:
  • ron, rublehousen
Reply
#5
Thumbs Up 
(21-11-2018, 01:47 PM)jj9 Wrote:  Hi,
It's often the spindles that the wiper arms fix to that are corroded in the sleeves.

If you can get to the crank part of the rack that connects to the motor take that off from the motor and move the rack by hand, if it's stiff it will probably be the spindles.

The spindles come out of the sleeves, there's normally a cir- clip holding them, clean the spindles and the sleeves and lubricate with silicone grease, you can also add a dab of grease to the balls & sockets on the linkage.

If the rack is nice and free with no stiffness maybe the motor is starting to seize, maybe a worn out bearing or bush.


.

 ^ this always helps any situation.....  Big Grin
Reply
#6
Absolutely   Big Grin



.
My vehicle .... 2006 (m59) Berlingo Multispace Desire - 1.6 HDI 92 
Reply
#7
linkages not too bad, but were significantly improved with WD40, so ive oiled my balls and greased the shafts. only took about 40 mins.

refitted to van but still a bit slow. seem better with higher engine revs. alternator is ok. im thinking motor wiring, earth in particular could be poor connection.

next stop is to check multiplug for corrosion etc.

at least ive eliminated linkages as the fault
Reply
#8
I would say the motor seen it many times.
[-] The following 1 user says Thank You to polar for this post:
  • rublehousen
Reply
#9
ive fixed it. took the motor off and removed clip on plastic cover. inside there is a brass contact that earths out on body of motor. like a prong that sticks up in a watch battery type affair.
there was a black build up on the brass contact and body (poor earthing) so cleaned it off and wipers now at full speed.
if fault returns i will put additional earth wire from pin 1 of the multiplug directly onto the alloy body of the motor as this contact inside seems a bit of a poor idea.
[-] The following 1 user says Thank You to rublehousen for this post:
  • ron
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
SURVEY
Last Post: Arfcollins
Today 03:17 PM
» Replies: 5
» Views: 55
I am selling my beloved Berlingo
Last Post: cancunia
Today 01:41 PM
» Replies: 1
» Views: 57
Door light switch - HELP!!!
Last Post: cancunia
Today 01:39 PM
» Replies: 3
» Views: 249
Injector/Cam Larder Studs 1.6 HDI
Last Post: Pippo
Today 11:18 AM
» Replies: 0
» Views: 64
Persistent EML - P0170 P40 - Help / Info needed
Last Post: Brico
Today 06:40 AM
» Replies: 3
» Views: 388
gearbox removal
Last Post: Art b
Yesterday 11:47 PM
» Replies: 4
» Views: 643
Grizz' Prozac for the Soul - Berlingo Multispace
Last Post: Grizz
Yesterday 08:30 PM
» Replies: 559
» Views: 104664
Undoing oil sump bolts.?
Last Post: Romahomepete
Yesterday 06:39 PM
» Replies: 9
» Views: 818
reversing mirrors
Last Post: frank
Yesterday 03:36 PM
» Replies: 2
» Views: 545
Highest mileage Berlingos
Last Post: Brico
Yesterday 11:30 AM
» Replies: 30
» Views: 9644

[-]
Recent Visitors
Locations of visitors to this page