Posts: 14
Threads: 9
Thanks Received: 1 in 1 posts
Thanks Given: 1
Joined: Dec 2014
Location: Essex
Reputation:
0
Hello there I have had a leaking injector and have got it out and cleaned it up and the seat does anyone know how to get plastic spacer out or hole or can I reuse old one?it is 1 bolt type or injector, also when I test fit injector back in its hole it doesn’t seem very snug is that normal!! Many thanks happy new year!
•
Posts: 335
Threads: 15
Thanks Received: 102 in 92 posts
Thanks Given: 15
Joined: Jun 2017
Location: Wales
Reputation:
6
G'day - plastic spacer bit I've usually left in but replaced the big rubber grommet and the copper washer down the bottom of the injector 'pit'.
It should be tight in there once you have all the bits tightened up - is the copper washer back in there OK?
•
Posts: 14
Threads: 9
Thanks Received: 1 in 1 posts
Thanks Given: 1
Joined: Dec 2014
Location: Essex
Reputation:
0
Thanks I hadn’t realised that the old injector seal had melted onto the injector that’s why I couldn’t find it, bolted it back up now just gotta fit new leak off pipe due to me snapping off green clips ,does anyone know a easy way to remove the leak off pipe?
•