[Engine] Torque Settings Alternator & Power Steering

[davescotbiker]

Hi
Does anyone happen to have the torque settings for alternator mounting hex bolts and power steering pump mounting hex bolt and allen bolts?
Fitting a replacement alternator to 2005 Berlingo 1.6 petrol (multispace)  and the power steering pump also has to come off to get clear access to alternator mounts.
Even then, 'clear access' is a relative term!!
Thanks in advance.
Dave

[oilyrag]

Power steering pump 22Nm, can't see alternator, but somewhere around the same!

[davescotbiker]

Power steering pump 22Nm, can't see alternator, but somewhere around the same!

Thank you oilyrag, much appreciated.
22nm does feel about right for the power steering pump mounts.
Alternator bolts are rather bigger (16mm hex socket where pump hex bolt is 13mm socket) and feel like torque should be higher - they were certainly much tighter to undo, but as none of the bolts have been undone since the car left the factory 17 years ago, that may be deceptive!

[oilyrag]

I guess it'll need to be ''tight enough not to fall off' but if in doubt use a spot of Loctite. Invariably there's not enough room for a torque wrench to many of the fittings anyway . Good luck!