09' Multispace to van conversion

[Sol]

Yeah I get that.

[jemselectrical]

Progress a bit slow recently, but whilst waiting for welding to be done, I've got some preemptive prep done for ply lining and setting out for the rear barn doors conversion. Once welding is done I can move forward with fixing in the ply lining. Finally received the rubberised mid floor section, so just got the front footwell section to get, then the cab area will be able to be completed

[jemselectrical]

Side load door trims offered up ready to install, and sound deadening as well today

[Sol]

Looking good!

[jemselectrical]

Bulkhead fabricated this weekend                    

Sent from my Pixel 6a using Tapatalk

[jemselectrical]

Cont'                    

Sent from my Pixel 6a using Tapatalk

[jemselectrical]

Cont'                    

Sent from my Pixel 6a using Tapatalk

[jemselectrical]

Cont'        

Sent from my Pixel 6a using Tapatalk

[Sol]

That looks great. You could sell that ply interior as a kit and make extra cash. It's the best I've seen done yet.

[jemselectrical]

That looks great. You could sell that ply interior as a kit and make extra cash. It's the best I've seen done yet.

Cheers, I didn't see anything available that did what I wanted and for the right cost, as this project is on a tight budget (vanguard metal one was £400+ ). I made templates to build it, so could potentially make more if there's interest. It's not quite finished yet as I'm covering the cab side and working out the fixing points

Sent from my Pixel 6a using Tapatalk