How to remove RH driveshaft?

[dvil]

Hi,
My clutch has fallen apart and I'm currently digging my way into the problemarea. Haynes just says "pull the shaft and intermediate bearing out", but it feels like it's welded in there. Have used quite an amount of force by a brakerbar onto the cv-joint and also a "pullerhammer". Won't move one mm.
I've loosened the two clampingbolts on the intermediate bearing, and it's free from the hub. Haven't done anything on the speedogear yet, as I understand from the book it doesn't interfere.
What am I missing? Please! cratch:

[andy-womble]

Should just slide out with a bit of a nudge ???
Watch out for the oil which will pee out at a rate of knots once the shaft is out!!!
Done that all over the drive on my old 306 which is a similar set up....

[dvil]

In for a quick update. It's out!
Found myself a brass bar and knocked on the diff side of the support bearing. Finally came loose. Pheeew.
Thanks.

[jimbo]

Glad it came out

[andy-womble]

In for a quick update. It's out!
Found myself a brass bar and knocked on the diff side of the support bearing. Finally came loose. Pheeew.
Thanks.

As we used to say when I worked for the NCB (National Coal Board)

"If in doubt, give it a clout" :lol::lol::lol: