Which idiot invented these trim clips?!

[nicebiscuit]

I mean seriously... They appear to be made out of Ryvita.

[brodfather11]

A now rich idiot , make them easily breakable so he can sell more .  

[Jed Clampit]

brodfather you cynic they wouldn't do that just for profit 

[Opensauce]

You can get a set of plastic trim removal tools from ebay for not much cost.

[brajomobil]

I mean seriously...  They appear to be made out of Ryvita.

http://www.berlingoforum.co.uk/thread-12223.html

Best regards,
brajomobil

[ffrenchie]

Is that special string or can we just use any brajo ? I like the push pin fittings where you plip the dot in the middle and they just pull out then you pull it out and push the dot in level to fasten it again. They should all use those and save us all a lot of trouble

[geoff]

[quote They should all use those and save us all a lot of trouble
[/quote]

Trouble is there are so many fuckwits out there that wouldn't know how to undo them and they would then end up on here complaining about them being rubbish !

[brajomobil]

Is that special string or can we just use any brajo ? I like the push pin fittings where you plip the dot in the middle and they just pull out then you pull it out and push the dot in level to fasten it again. They should all use those and save us all a lot of trouble

Any string. I used the one for parcel shipping.

Best regards,
brajomobil

[nicebiscuit]

I'll try that tip, thanks.

The trouble with these we're that they were the ones on the tailgate trim where you can't access the clip easily from the outside...