Posts: 4
Threads: 1
Thanks Received: 0 in 0 posts
Thanks Given: 1
Joined: Feb 2013
Location: uk
Reputation:
0
22-02-2013, 07:35 PM
(This post was last modified: 22-02-2013, 10:11 PM by brit.)
HI ALL NEW TO FORUM NEED HELP PLEASE,CITROEN BERLINGO 56 PLATE 1868CC,HAD VAN PLUGGED IN TODAY AT GARAGE & CAME UP WITH FAULT CODE P1109 (RELAY COOLING VENT) CHECKED ON FORUMS SAYING" AIR INTAKE TEMERATURE SENSOR" CAN ANY ONE TELL ME DOES THIS SOUND CORRECT IF SO WHERE IS THE SENSOR LOCATED. (DW8 WJY ENGINE)
ENGINE MANAGEMENT LIGHT IS ON,IF I REV IT TO 3500 RPM THE LIGHT GOES OUT,THEN IF I PUT IT BACK TO TICK OVER,AFTER ABOUT 10 SEC"S THE LIGHT COMES BACK ON & THERE IS A BEEP FROM THE DASH BOARD AREA.IF THE MAF SENSOR IS REPLACED DOES THE CODE NEED ERASING FOR THE NEW MAF SENSOR TO WORK ??? ANY ADVISE PLEASE !!
•
Posts: 476
Threads: 17
Thanks Received: 117 in 92 posts
Thanks Given: 153
Joined: Feb 2011
Location: Rayleigh Essex UK
Reputation:
0
http://img16.imageshack.us/img16/7338/imgp0287.jpg
this is where the air intake sensor is located... next to the MAF just after air filter, you can see it poking down in the photo. Not sure on the code though, or if it is related to the sensor itself.
BBA reman says this!
http://www.bba-reman.com/content.aspx?co...BD_P_Codes
Adam..2003..1.9D..LX..Silver Crew Cab Van.....
If at first you don't succeed, destroy all evidence that you tried.
Posts: 4
Threads: 1
Thanks Received: 0 in 0 posts
Thanks Given: 1
Joined: Feb 2013
Location: uk
Reputation:
0
hi thanks for that,so does that mean the sensor is actually part of the maff then ?:eek:
•
Posts: 476
Threads: 17
Thanks Received: 117 in 92 posts
Thanks Given: 153
Joined: Feb 2011
Location: Rayleigh Essex UK
Reputation:
0
No, is a separate part I think. Is under the grey connector in the photo, have to disconnect the connector and then prise apart the square bit where the sensor plugs in. May just be dirty? Check the contacts..
Adam..2003..1.9D..LX..Silver Crew Cab Van.....
If at first you don't succeed, destroy all evidence that you tried.
•