Multi Function Display

[Coco]

This is something I've been icking around for a while now - see previous posts on it.

My experience so far is that it's a definite maybe !

I have the correct stalk, but without the appropriate end. However, you can get round this by using a paper clip or a Biro inner to perform the switch function.

My display is the simple one. There are various ones listed on Servicebox butthey are too expensive to buy on the off chance and on my trips to local scrapyards there has never been a suitable one available to take a chance on.

I have had mine hooked up to Planet (the proper version of Lexia) and it said that the function did not exist. The person doing this said that this referred to the facility in the ECU, not on which display module was present so that even if I had the correct module it wouldn't work. I'm not convinced.

If I can find a suitable display module at a reasonable price then I wsill try, but I'm not going to spend a fortune, or start cutting the trim to fit something that might not work.

Will be glad for any advice though