Thread Rating:
  • 21 Vote(s) - 2.29 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Will the Engine Management Light fail an MOT??
#21
http://www.theaa.com/motoring_advice/car...-2012.html

There is an "advisory" period of grace and this has been extended until the end of the year
[-] The following 1 user says Thank You to Coco for this post:
  • ST12AT
Reply
#22
(25-10-2012, 10:03 PM)prunty Wrote:  If it wasn't doing it's job should the management light not come on?? At the minute it is staying off. And if it wasn't doing it's job and I am loosing fuel pressure what are the consequences of low fuel pressure??

What is the function of the of the pressure switch and what effect would a malfunctioning one have??

Is it possible that the switch is malfunctioning if the light is staying off??
Reply
#23
Could be, Check the connections on the switch.
This switch has electronics inside it so a bad connection on any of the three wires will cause it to fault.
Next thing to try would be a new switch (pricey) but if you can find someone with lexia or pp2000 it might give you a more accurate fault read. Confusedalut:
2006 2.0hdi 600 with bench seat.  Cool
Reply
#24
An update on this, a mate of mine has a wee device that can put out the light so after putting the light out a few times the issue seems to have corrected it's self and I haven't had an issue for a good while now. So fingers crossed...
[-] The following 1 user says Thank You to prunty for this post:
  • ron
Reply
#25
I'm a mot tester and a engine management light on is ONLY a advise
[-] The following 1 user says Thank You to Curb side for this post:
  • ron
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
Do thing right themselves?
Last Post: Anyinfo
Today 10:57 PM
» Replies: 3
» Views: 156
Rear Suspension Rebuilders?
Last Post: smutts
Today 08:02 PM
» Replies: 6
» Views: 192
Thoughts on Leisure battery powering radio when ...
Last Post: smutts
Today 07:45 PM
» Replies: 1
» Views: 31
Bolt torque settings
Last Post: LukeC
Today 07:21 PM
» Replies: 2
» Views: 33
Solenoid location
Last Post: OMG
Today 06:07 PM
» Replies: 2
» Views: 96
2012 1.6hdi Won't start!
Last Post: smutts
Today 03:06 PM
» Replies: 5
» Views: 542
roof rack
Last Post: Vowders
Today 12:33 PM
» Replies: 0
» Views: 29
Oil sump design.
Last Post: evdama
Today 10:59 AM
» Replies: 10
» Views: 720
Amdro Dometic Origo stove can it be changed to g...
Last Post: Wightlingo
Today 07:56 AM
» Replies: 2
» Views: 97
buying advice - bonnet release lever broken
Last Post: geoff
Today 06:51 AM
» Replies: 4
» Views: 128

[-]
Recent Visitors
Locations of visitors to this page

[-]
Hosting by

QuickHostUK