Thread Rating:
  • 2 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
instrument cluster problem
#1
i have a 2000 berlingo 1.9d, The problem with the instrument cluster is that the speedo, mileage(you can see part of the mileage)
and rev counter dosent work atall
The temp gauge,fuel gauge and spedo still work, any ideas what i need to do to remedy or is it a case of new clocks? if so is it just a straight swap with a matching set?
Reply
#2
Hi Danny, if the car is multiplexed it's not always good to do a straight swap. I believe sometimes the systems will add up both the old mileage and new!

If you're lucky and it's early 2000 (say, before April) then it is less likely to be multiplexed and you can simply swap for another diesel dash set.
Reply
#3
Thanks for the reply, iv edited the 1st post as the spedo dose work its the milage and rev hand dosent work!
Reply
#4
In the driver's door opening, there's a small white sticker with three lines on it. What's the first line on the sticker (it will usually be five numbers followed by two letters)?
Reply
#5
The 1st line would be 08642fv, what is these for or what will it tell you?
Reply
#6
The RPO is 08642, this is a multiplexed van. Before 08600 were the easier ones to work on.

It also means your cluster can't be so easily swapped. My warnings about mileage apply to your van...
[-] The following 1 user says Thank You to addo for this post:
  • danny06
Reply
#7
Just my luck then, so what way could i go about it? even if i just got my milage clock working/showing id be happy! my best bet would be to leave it with an auto spark i guess.
Reply
#8
I think if you fit the complete kit from a matching spec car that works, it will be fine. This is the dash, the BSI, the COMM unit, ECU and key chips.
Reply
#9
Hi, have you done the basics? Check all fuses inside & engine bay and try a Bsi reset procedure. :thumbsup:
I'm presuming that you have a digital mileage with only half of the digits showing?

http://www.bba-reman.com/content.aspx?co...ot_process
2006 2.0hdi 600 with bench seat.  Cool
Reply
#10
Tbh no I havent checked the fuses as didn't think it would be them, also wot is a Bsi reset procedure and how do I go about it?

Yes it is digital wit onl bits showing, sometimes more than other times!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)
[-]
Welcome
You have to register before you can post on our site.

Username:
  

Password:
  




[-]
Search
(Advanced Search)

[-]
Latest Threads
2012 1.6hdi Won't start!
Last Post: smutts
Today 03:06 PM
» Replies: 5
» Views: 535
roof rack
Last Post: Vowders
Today 12:33 PM
» Replies: 0
» Views: 27
Oil sump design.
Last Post: evdama
Today 10:59 AM
» Replies: 10
» Views: 717
Amdro Dometic Origo stove can it be changed to g...
Last Post: Wightlingo
Today 07:56 AM
» Replies: 2
» Views: 87
buying advice - bonnet release lever broken
Last Post: geoff
Today 06:51 AM
» Replies: 4
» Views: 123
Solenoid location
Last Post: saskak
Yesterday 07:30 PM
» Replies: 1
» Views: 87
OBD Faults listed - which how to fix?
Last Post: Anyinfo
12-05-2024 11:38 PM
» Replies: 3
» Views: 157
Do thing right themselves?
Last Post: Leonberger
12-05-2024 08:54 PM
» Replies: 1
» Views: 123
Rear Suspension Rebuilders?
Last Post: smutts
12-05-2024 03:37 PM
» Replies: 5
» Views: 182
2023 electric
Last Post: Anyinfo
12-05-2024 09:43 AM
» Replies: 5
» Views: 157

[-]
Recent Visitors
Locations of visitors to this page

[-]
Hosting by

QuickHostUK