Posts: 10
Threads: 3
Thanks Received: 0 in 0 posts
Thanks Given: 0
Joined: Mar 2015
Location: UK
Reputation:
0
Needed to replace one of the capless bulbs in the fron interior light, and noticed there is an unused connector attached to the same wire - it goes to where a vent-looking hole is at the front of the plastic part.
Anyone got any ideas at what it is for ?
My best guess would be interior alarm sensor (btw can the alarm be easily fitted after market from original bits?)
Thanks
•
Posts: 10
Threads: 3
Thanks Received: 0 in 0 posts
Thanks Given: 0
Joined: Mar 2015
Location: UK
Reputation:
0
I'll try and get a photo tomorrow.
It's a two wire connector held onto the plastic trim inside the light unit.
The "vent-looking hole" looks about the size of a 2p coin and is just before the interior light (if looking at it from the drivers seat)
•
Posts: 993
Threads: 23
Thanks Received: 231 in 198 posts
Thanks Given: 46
Joined: Nov 2011
Location: N/W Kent
Reputation:
5
It is a microphone for (well on mine) a Bluetooth phone
--------------------------------------------------------------
2012 Iron Grey XTR 110 with lots of bits and bobs.
•
Posts: 24
Threads: 5
Thanks Received: 6 in 6 posts
Thanks Given: 0
Joined: May 2014
Location: Ashton under Lyne
Reputation:
0
Can confirm with Trevor it's for the Hands free Microphone. The other end of the cable should be behind the front pillar lower trim Drivers side. Can't confirm that at the moment.
•