1. Removing
Disconnect the battery .
Remove :
The tail lights
The rear mud shields
[Image: rrbp1.png]
Remove :
The screws (3) and (4) (in the wheel arch) (on each side)
The screws (1) and (5)
The bolts (2)
Release the clips (6).
Remove : The external bumper skin (7).
[Image: rrbp2.png]
Remove :
The bolts (8)
The bumper absorber (9)
2. Refitting
2.1. Recovered bumper support
Proceed in the reverse order to removal.
Tighten the screws (1), (2), (3), (4), (5), (6), (8) to 0,8 m.daN .
Connect the battery.
Check all the equipment works.
2.2. New bumper support
[Image: rrbp3.png]
A : Previous assembly.
B : New assembly.
ATTENTION : When replacing an old bumper, the fixings ( 11), (12) must be ordered.
Only the later parts will be available from Parts Div..
Remove the retaining clip ( 10) fixed inside the rear wing (on each side).
Fit :
The cage nut (11) on the rear wing (on each side)
The rear bumper
The (12) bolt (on each side)
Proceed in the reverse order to removal.
Check all the equipment works.
Disconnect the battery .
Remove :
The tail lights
The rear mud shields
[Image: rrbp1.png]
Remove :
The screws (3) and (4) (in the wheel arch) (on each side)
The screws (1) and (5)
The bolts (2)
Release the clips (6).
Remove : The external bumper skin (7).
[Image: rrbp2.png]
Remove :
The bolts (8)
The bumper absorber (9)
2. Refitting
2.1. Recovered bumper support
Proceed in the reverse order to removal.
Tighten the screws (1), (2), (3), (4), (5), (6), (8) to 0,8 m.daN .
Connect the battery.
Check all the equipment works.
2.2. New bumper support
[Image: rrbp3.png]
A : Previous assembly.
B : New assembly.
ATTENTION : When replacing an old bumper, the fixings ( 11), (12) must be ordered.
Only the later parts will be available from Parts Div..
Remove the retaining clip ( 10) fixed inside the rear wing (on each side).
Fit :
The cage nut (11) on the rear wing (on each side)
The rear bumper
The (12) bolt (on each side)
Proceed in the reverse order to removal.
Check all the equipment works.